Spec validation tool allows mass model updates when specifications are updated. Often specs are in early design stages when modeling starts. When bolts or gaskets have updates, replacing these components as currently setup takes a significant amou...

In the industry there are cases where a circular (ring shaped) header manifolds that branches equally to feed fluids to a sub system are needed. For example, a cooling water distribution system. Currently, Openplant has limited functionality to ac...

When we change the spec of a Custom Piping Component, the graphics are reset to OPM default 3D Geometry

There are many, many components missing the sketches which are shown in the catalog editor when one wants to create a new component. Please update these, so all components get the documentation. Also compile them in a PDF, listed by the different ...

Adding a dropdown to the Measure Tool to allow the user to change the measurement unit. Currently, the only way to Measure in different units is to change the Design File Working Units, however, this causes other issues and permanently changes Wor...

After Bentley ended support for Navigator v8i, Bentley is missing a desktop-based review tool that supports dynamic review of Openplant DGN files stored in a ProjectWise Environment. While working in a File Based system, it is essential to have a ...

In a File Based CAD Environment, the File Name is used to identify systems and other details about a model. Currently, users need to add this data manually to different piping and equipment components. When a file name changes, we find that design...

Using Explorer View, PlantSIght Tab to check Pipelines and Equipment out into OPM works fine for smaller models, but when you ahve 46k Tags the process can take hours to check each individual Pipeline or Equipment out for a project. The ability to...

OPM has a config variable OPM_CALCULATE_BOLT_LENGTH which controls if the tool automatically calculates the required bolt length or uses the value from the Spec. We would like to use the values defined in our spec in all cases, except for Wafer ty...

When we run a Validate from Spec command, by default OPM uses SPEC ID to validate all the other properties of Piping Component. I have some older models that have duplicate SPEC IDs. If we had the ability to tell OPM to use a different property fo...