Would like ability to better customize the cable pull cards
It would be helpful if cable pull cards could be more customized to allow options like: Exclude length for air gaps Exclude additional lengths However, it would be still good to include these lengths in the overall total length calculation. See at...
Would like a setting to create the Raceway ID on same level as selected raceway´s. The setting could possibly be added to Options>CAD Standards>Levels dialog and set entry like this: e.g. Raceway ID =<Raceway Voltage Level>
Optimize multiple small RW sections into largest catalog available RW section
It happens that one straight RW section contains multiple smaller RW sections. for example instead of having 1 10 ft section, you may end up with one 4' and one 6' section next to each other. This creates problems with supports locations. Ideally,...
In the Options>Raceway Specifications dialog it should be possible to combine the properties for routing filters with operators like 'and' 'or'. Example: A cable should be allowed to use CTRL or IW raceways for routing. At the moment, it's not ...
We should support placing conduit in a oblique direction in 3D
Currently the conduit only can be placed in a oblique direction on 2D plane, it cannot be placed in a oblique direction in 3D, the x, y, z values changed together which would sometimes be helpful.
When using the raceway generator it would be nice to be able to generate flexible conduit that follows a spline curve and adds couplers whenever required. We want to ensure that we can report on the flexible conduit and coupler parts accurately in...
BRCM Component (raceway) can't use the Attach Material" tool. Need to use "Drop Element" to be able to do so but the BRCM properties will be gone. It will be really helpful if the "Attach Material" tool can be used to apply to BRCM component as well.
Raceway Size tool: automatically avoid illegal and deletion of bend fittings
When using the Raceway Size tool to change the size of already inserted conduit, BRCM does not adjust the radius of any bends, only the size. This can result in bends with less than the NEC minimum bend radius or bends being deleted if the resulti...
Would like additional options in the raceway offset tool: Should have option to select "segment" instead of only "Route" in raceway offset command. Function currently uses right-click to accept. Should be left-click like all other tools Offset pro...