Need Support? Let’s guide you to the right answer or agent.

OpenPlant Ideas Portal

ADD A NEW IDEA

All ideas

Showing 247

Wafer Bolt - Two bolts in the spec with the same nominal diameter and BOLT_LEN but different Description, OPM picks the first spec entry.

OpenPlant Modeler’s working behavior is to pull the nearest bolt entry from spec with a lower BOLT_LEN compared to the calculated length if there’s no available bolt entry from spec with a BOLT_LEN that is either equal or greater than the calculat...
about 1 year ago in OpenPlant Modeler 0 Future consideration

Assembly Manager in OPM

Users would be able to place multiple OPM-components in one go by creating a user defined component library, with retaining individual properties per component. Todays´ capabilities don´t hold individual properties (place custom component from cel...
over 2 years ago in OpenPlant Modeler 1 Future consideration

Tag Replication to display full tag

When using the tag replication tool, the main tag indicates replication by adding the number of replicated components in parenthesis. What we would like to see is for the replication tool to prompt the user to place each replicated tag annotation ...
over 1 year ago in OpenPlant PID 0 Future consideration

Ability to rotate text vertically on the dim line

Currently OPIM determines what orientation the dimension text should be based on the oriental of the dim extension lines. The request would be to tell opim the all dim text would be vertical instead of it being mixed like shown in the attached image.
9 months ago in OpenPlant Isometrics Manager 1 Future consideration

Enhance Valve Placement to allow users to set the valve state, actuator, and end condition properties in the placement dialog

As a piping designer, I would like to be able to set the valve state, actuator, and end conditions in the placement dialog so that I can initially set what I need and don't have to change it later by modifying the property values. Proposed Solutio...
about 1 year ago in OpenPlant PID 0 Future consideration

Stretch Components Tool

Sometimes the drawing is generated unreadable.With this tool we can stretch the component to a readable space in the drawing.
about 1 year ago in OpenPlant Isometrics Manager 0 Future consideration

Validation of Component Dimensions

OPM users need a way to check dimensions of components against the pipespecs. We have had several instances where pipespec dimensions get updated by piping engineering after OPM Users have already routed in the model. OPM users currently have no w...
about 2 years ago in OpenPlant Modeler 0 Future consideration

Display Manager Apply without closing tool

It would be useful it we could apply Display Manager settings without closing out the tool. Currently the only way to apply the display is to select OK and close the tool box. This slows down the user if they want to toggle back and forth with dis...
7 months ago in Bentley Raceway and Cable Management 0 Future consideration

Add ability to select and add multiple runs to Pipelines using the Add Run tool

Currently the Add Run to Pipeline tool only allows one pipe run at the time to be selected and added to a Pipeline. This request is to add the functionality so that multiple Pipe Runs can be selected and then added to a specific Pipeline. This mos...
8 months ago in OpenPlant PID 0 Future consideration

Enable direct reporting capability from PlantSight EDM.

Enable reporting output to PDF with ability to format, customize, compile/bind and save project settings.
about 1 year ago in OpenPlant Engineering Data Manager 0 Future consideration