Need Support? Let’s guide you to the right answer or agent.

OpenPlant Ideas Portal

ADD A NEW IDEA

All ideas

Showing 295

Measurement Legend will help new user to model supports fast and avoid confusion.

Currently, it can be seen, the image of support while placing in OPSE upon hovering on it. Requirement here is to get the option in placement dialogue of supports in OPSE in which one can see the image of support to place with the legend of dimens...
11 months ago in OpenPlant Support Engineering 0 Future consideration

Add support custom xml schema

Users add customization to OpenPlant_3D.01.08.ecschema.xml and other Supplemental schemas. They want to have one separated schema where will be available option to create new classes and properties and not change initial schemas. This will help to...
almost 4 years ago in OpenPlant Modeler 1 Future consideration

Wafer Bolt - Two bolts in the spec with the same nominal diameter and BOLT_LEN but different Description, OPM picks the first spec entry.

OpenPlant Modeler’s working behavior is to pull the nearest bolt entry from spec with a lower BOLT_LEN compared to the calculated length if there’s no available bolt entry from spec with a BOLT_LEN that is either equal or greater than the calculat...
almost 2 years ago in OpenPlant Modeler 0 Future consideration

Possibility to add graphical representation of counter flange for fittings like strainer, bellows, flow meter, etc.

Possibility to add graphical representation of counter flange for fittings like strainer, bellows, flow meter, etc. Similar to end condition mappings End Condition Extend Type for valves.
12 months ago in OpenPlant PID 0 Future consideration

Enhance Valve Placement to allow users to set the valve state, actuator, and end condition properties in the placement dialog

As a piping designer, I would like to be able to set the valve state, actuator, and end conditions in the placement dialog so that I can initially set what I need and don't have to change it later by modifying the property values. Proposed Solutio...
almost 2 years ago in OpenPlant PID 0 Future consideration

Stretch Components Tool

Sometimes the drawing is generated unreadable.With this tool we can stretch the component to a readable space in the drawing.
almost 2 years ago in OpenPlant Isometrics Manager 0 Future consideration

Page connectors to link in file based mode.

Currently page connectors only link from drawing to drawing while using Plantsight. We need this when using file based mode also.
over 4 years ago in OpenPlant PID 0 Future consideration

Piping AutoRouting via “AutoPath” or “Connect to.." options.

Currently we don’t have such functionality in OP compared to what we have available in AutoPLANT Modeler. In some cases, it would be very helpful and more productive to automatically finish the pipe routing with possible alternative routing option...
over 4 years ago in OpenPlant Modeler 0 Future consideration

Creating Intelligent Equipment in BRCM CE (Similar to OPM "Create Equipment" feature)

Please note that we have two procedures for BRCM equipment modeling and that are :- Minor Equipment Modeling >>> In this we have been used Internal BRCM library and all equipment’s are intelligent. (Due to its intelligence we can easily f...
about 2 years ago in Bentley Raceway and Cable Management 1 Future consideration

Copying equipment should automatically assign the next available ID.

When you copy equipment it should automatically rename the equipment-ID to the next possible ID to avoid creating duplicate IDs. The software could apply a default ID format to define the next available ID. This should be supported for both of the...
about 2 years ago in Bentley Raceway and Cable Management 0 Future consideration