OPIM must read dms folders directly. Do not create subfolders like: C:\PW_ADMIN_WD\dms02651\styles\IFC\config and C:\PW_ADMIN_WD\dms01754\Workspaces\WorkSpace\Worksets\OpenPlantMetric\Standards\OpenPlant\Isometrics\styles\IFC\config This gives man...

Currently adding the conduit to an existing duct bank or already modelled duct bank is not possible. In projects it is very frequent to change the duct bank matrix which after modelling the duct bank. If after modelling new conduit is required to ...

Heat calculation must be performed on duct bank for certain circuits and it is important to be able to designate certain conduits for a particular circuit. It would be very helpful to be able to upload a dedications list into BRCM that instructs t...

I think the current equipment manager is very confusing. It takes a long time to find and select something when you have a lot of equipment to choose from. I suggest the dialog window with a directory structure with categories -Cabinites -motors -...

As a piping designer, I would like to be able to set the valve state, actuator, and end conditions in the placement dialog so that I can initially set what I need and don't have to change it later by modifying the property values. Proposed Solutio...

Sometimes the drawing is generated unreadable.With this tool we can stretch the component to a readable space in the drawing.

There are times where a single value for the variable OPM_MISALIGNMENT_ALLOWANCE is not best for project use. For cases like flanged joints, this should be near zero, for cases such as socket welds this can be as much as 1 degree. For butt welds, ...

Item Counter and Indexing: Propose the addition of item counters or row numbers to facilitate matching components between lists, improving traceability and reducing confusion during the update process.

Spec Change Tool Dialog - Component Matching and Highlighting: The tool should automatically highlight and match corresponding components when selections are made, making it easier to identify and replace items accurately.

We would like to manage the slope symbol quantity in the same angle pipe. The symbols are located on each point currently. But we don't need multiple symbols in the same angle's pipe. The previous engine(isogen) does not locate the multiple symbol...